**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[Brother Esau]

LOL the Transpiper thing is a PITA yes?

I triied it on the SB and got minimal effect--I dug around in the parts bins and found a Nidec off an old AMD HSF and it fit great--could not figure out why that metal bracket was there. Took it off and the clips work great on the plastic thing that mounts the Nidec to an AMD HS--still did feel any heat leeching off the Mosfet or NB..

So I remounted it on the Mosfet and hung it out the back--but this is a tech station so I angled it to be as far from my ears as possible

I could not see putting that metal plate between the CPU and WaterBlock. Has anyone tried that yet? But I found the smaller plate will work fine on that application--so you can hang the Transpiper out the back without involving the CPU in some sort of kinky threeway...

Tried some settings I was using on the Inifnity and got right onto Folding at 3200 ( 8 x 400) without issue.

I did not even have to mess with SW--the RAID install from the Infinity was received by the LanParty and the only updates were to the Lan and Audio.

Extremely happy with the board temps and the CPU temp. To be running at 4C over ambient at load overvolted and overclocked is stunning.

This puts my P5K Deluxe to shame.

@CyberDruid........What size is that Fan that you stuck on the Transpiper 70mm? I had ordered a 60mm from the Egg with my Cross Blower thingy for my Stacker and its too small



Also as a Point of Interest I think that if you install that copper plate in conjuction with that water cooling you will be styling!

[CyberDruid]

CyberDruid, nice benching chassis you have their.. home built ?

Yep: I never got over playing with erector sets

@CyberDruid........What size is that Fan that you stuck on the Transpiper 70mm? I had ordered a 60mm from the Egg with my Cross Blower thingy for my Stacker and its too small



Also as a Point of Interest I think that if you install that copper plate in conjuction with that water cooling you will be styling!

Lol not sure--I stole it off an AMD heatsink.

I dunno about the plate between CPU/WB but it will be easy enough to try.

I guess the T-piper works: the chipset temps are 10C lower than my hotblooded P5K deluxe.

I am seeing good times on the WUs...averaging 8 minutes to finish one percent of a SMP Gromacs at 3200--that's a tad faster than the P5K at the same rate..with faster RAM...hmmmm...time for more tweaking