Quote Originally Posted by GameGuru View Post
Hey Ace my PWM temps are through the roof. I did the heatpipe mod, used a little MX-1 and tossed the thermal pad that it came with and have a 40mm fan blowing on it. I think maybe I tightened the bolts to tight. On load it's getting around 80+. What would you suggest?

Thanks!

hmmmm, i would say the heatsink is not sittling level on the mosfets....i pulled out my QuadGT board to re-do the PWM mod by switching out the plastic push pins with the nuts and bolts...when i remounted the heatsink, i did not make sure it was level on the "digital" pwm's...so...2 out of the 5 were not "even" touching the heatsink...i was safe for idle conditions but not for priming...and...in a matter of a few minutes, i burned the heck out of one of the digital PWM's...board is dead!