hey dinos, can you help me? my q600 L727A673(same batch as yours) is running at 3.4Ghz with temps of 38-67C and is aircooled by a tuniq120. i'm using crucials 8500 for my rams. prime95 stable for 8 hours.

these are my settings...

Ratio CMOS Setting 9
FSB Strap To North Bridge(Mhz) 333
FSB Frequency 380
PCIE Frequency 100
DRAM Frequency AUTO ***
DRAM Command Rate AUTO
DRAM Timing Control Manual
CAS# Latency 5
RAS# To CAS# Delay 5
RAS# Precharge 5
RAS# Active Time 15
RAS# To RAS# Delay AUTO
Row Refresh Cycle Time AUTO
Write Recovery time AUTO
Write To Read Delay AUTO
Read To Precharge time AUTO
DRAM Static Control Disabled

Transaction Booster Enabled
Boost Level 1
Clock Over-Charging Mode AUTO
CPU Spread Spectrum Disabled
PCIE Spread Spectrum Disabled

CPU Voltage 1.375 : pencil mod -1.376 CPUZ
CPU Voltage Reference 0.63x ***
CPU Voltage Damper AUTO
CPU PLL Voltage 1.8***
DRAM Voltage 2.2
FSB Termination Voltage 1.4***
North Bridge Voltage 1.4
North Bridge Voltage Reference 0.67x***
South Bridge Voltage 1.05***

I've marked the settings that confuse me, as i don't exactly know what they are for and what is optimal for my rig. please give me insight on thier purpose so i can oc better. as for the rams i intend to tighten them later.