Quote Originally Posted by Timbosan View Post
yeah vdimm is ram voltage, i use about 2.1v on all ram, the red is pretty much just to let you know you've gone over standard.

Try this:

vcore = 1.35 - 1.40v
set 401 FSB
RAM timing = 5-5-5-15-6-42-10-10-10-15 (down the page)
Vdimm = 2.1v

Hi:
I have been trying a combination of these settings over the past week. Normally I can boot with no problem but when I run Orthos, the system will reboot after a while. The temps for the cores are normal, but I I get around 71 C after a while for CPU (not cores). This reading has always been high, even when I had a prescott processor in this board a few months ago. I think something gets too hot (northbridge or ram but I donīt have sensors for them) and causing it to reboot.

I have 1 120 fan coming in and 2 120 fans going out. Room temp about 21 C

Any thoughts?

Thanks