**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[nachthymnen]

Anyone know if there's problems with Topower 750W psu?
TKS

[pippo369]

Anyone know if there's problems with Topower 750W psu?
TKS

I don't think, i have this mainboard with Topower PT700 and no problem.

[luihed]

Anybody know where the measuring point for vdimm is? also when you power up, should the Dram Power led turn red? mine stays yellow and the manual says if its red, theres power in dimm socket...

[jimmyz]

Anybody know where the measuring point for vdimm is? also when you power up, should the Dram Power led turn red? mine stays yellow and the manual says if its red, theres power in dimm socket...

mine stays yellow, don't think it can turn red? c1 error won't go away with different ram or a cmos clear?
my board got here saturday and i have had a lot of issues with my d9gmh (4 different sets of ram) they all will do ddr2 1000 with 4-4-4-9 but won't boot with 5-5-5-15 @ 1067 ? weird stuff.

[luihed]

I would imagine most people that runs this board are using D9GMH including me but I also have a stick of value rams for troubleshooting....

Tried everything I can think off, I plugged in the extra floppy connector eventhough Im only using a pci card ( lol ) and i actually got passed C1.... it went C1, 26, .. and I thought I got though but it rebooted and stuck at C1 again.... if this board had 5 led Im sure it would have read P.S.Y.C.H .....

I was reading the manual and it said that if the dram led was red theres power in the dimm socket so I thought yellow means it doesnt have power....

Dont have a case so it cant be grounded and my waterblock was tighened lightly so Im lost to what can be causing this.... It ran without any problems today, even after I flashed the bios everything was fine then I shut it down.... Never fired again... didnt even abused it yet ...

This is the same crap I went through with the Ip35 and I thought it was the board thats why I swithch to DFI... Now it has to be something else, it could be me but Ive been doing this a long time ( see my joined date ) and Ive never killed a board till this chipset... Looking at Brother Esau's HW, were both using Silverstone PSU and ballistix 8500s, but Ive used ballistix and this PSU on my commando and 965-s without any problems...

[cantankerous]

My board is due here Tomorrow and guess what? I too am using a Silverstone DA750 and have 4GB of Crucial Ballistix Tracer coming in along with the board. I really do hope I don't have these issues. I think I am going to run stock for a good week to be sure things are good before I start pushing. That way I will know if it is the board acting up for my doing. I want the board to have some burn in time before I push it, should be safer this way.

Praz brings up a very interesting case regarding the C1 and a power down instead of a reboot. If anyone gets a C1 error in the near future try this and see how it fares.