Quote Originally Posted by fornowagain View Post
That's what its supposed to do, set the voltage in bios, connect the multimeter (my uguru values are -0.02v from actual). Load the cores, and wind the vr down in resistance and stop when the voltage rises to meet the bios set value. Take it off load and see how much it changes, mine only moves 0.005v
I'm not getting any resistance reading on my mod. I'm wondering if I'm taking the reading from the wrong place or the resistor is bad (although I have no vdroop, actually it goes up 0.008 to 0.010 from idle). I just bought a replacement DMM today too. I get no reading even at 2000 Ohm. I took both reading from the vcore measure are and then tried the actual resistors the wires were soldered to. Nothing. Nothing happends or changes when I rotate the resistor either, even 6 or 7 turns.