**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[C-N]

Panic over I have finally got to the bottom of my problem of not being able to run over prime blend over 400fsb on this board with a Q6600.

Please don't all kick me at once it was the dammed PSU playing up.

I had actually swapped out the PSU trying to eliminate it but I must have been too far off with my settings to notice the difference between a crash due to a PSU fault & an unstable crash

My old boss used to say things like this were character building & you know what I think I finally got what he was on about now although this has given me a Jackal & Hyde character as last night I was ready to put a hammer through this board fuming with rage yet now with the weight off my shoulders & the board priming at 450fsb I feel like kissing it.

CN

[C-N]

She's trucking now, it feels like a different board.

The PWM & NB are running cool as ice passively cooled with relatively low voltage.

Voltages in BIOS.

CPU VID Control: 1.45v
CPU VID Special Add: AUTO
DRAM Voltage Control: 2.230
SB 1.05V Voltage: 1.070v
SB Core/CPU PLL Voltage: 1.55v
NB Core Voltage: 1.50v
CPU VTT Voltage: 1.60v
Vcore Droop Control: Disabled
Clockgen Voltage Control: 3.45v
GTL+ Buffers Strength: Strong
Host Slew Rate: Weak
GTL REF Voltage Control: Disable
x CPU GTL1/3 REF Volt: 110
x CPU GTL 0/2 REF Volt: 110
x North Bridge GTL REF Volt: 110

CN