*Official Retail G0 Q6600 Overclocking Thread*

[nugzo]

1.4-1.39v loaded so far probably be my 24/7 setup, the temps are still ok, its under water, and hopefully after few days of use the temps will go down 2-3c and may be i can oc more, i just want to stay in the 60's, thats it. i think i can probably push 3700, but that will probably border line max stable i would rather have little room to spare.

and yeah its pretty funny i dont even dream about hitting 4ghz on quads, 3.6 is pretty damn fast enough, and should last me good few years, well its not like i wont upgrade when penryn comes along and may be get 4ghz than.



the temps are 66-68, under load and prime has been running for 2 hours now, probably finish one loop in an hour or so. than i would try to squeeze every last megahertz at this same voltage. watercooled by d-tek fusion waterblock and please people dont say my temps are high for my setup, cuz it simply hurts my feelings(lol), my b3 was doing the same temps at 3.2.

Is your ultra in the same loop as the cpu? My temps loaded @ 3700 1.45v were around 58-62c. Now with both ultras in loop i'm at 68-72c loaded small fft with fusion. I hope you just made a mistake in you sig when u say your average room temp is 68-72c. That should be 68-72F Correct? lol if not, you have 1 hot room!!