**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[hansbroken]

Question to Ace-a-Rue (or anyone else that remounted the heatpipe cooling on this MB for the chipset etc..)

I'm waiting on my IP-35Pro to arrive. And I am planning on remounting the heatpipe cooling on this board as per your guide. However, I don't have much in my inventory for 40mm fans. I do have one 40mm x 20mm. But, it looks like you are using 40mm x 10mm fans. Will a 40mm x 20mm fan be too thick? I am going with the same heat sink (TR 120 Extreme) BTW.

I cannot tell 100% by the pics, but it looks like a 20mm thick fan may not fit very well..?? Possibly on the NB part. But it looks too tight on the PWM part.

I like the 20mm thick fans, as they seem to move a bit more air with less noise. But if they won't fit, then what's the point.

Also I have to add: thanks a lot for all the effort you put into providing some very helpful info! ... and a hats off to Nelly & everyone else that have contributed to this thread as well .. Thanks ya'all