**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Magic Chief]

Actually it still does it. I can't install a free Age of Empires 2 demo to see if my downloads are still corrupt. I also try to install VLC media player and can't. I am not overclocking and have everything at stock voltages. I have also put the memory in different slots and still get the problem. I also ran memtest and got 0 errors. Could it be the board?
CPU 1.25v
DDRII 2.2v at 5-5-5-15

[Ace-a-Rue]

Actually it still does it. I can't install a free Age of Empires 2 demo to see if my downloads are still corrupt. I also try to install VLC media player and can't. I am not overclocking and have everything at stock voltages. I have also put the memory in different slots and still get the problem. I also ran memtest and got 0 errors. Could it be the board?
CPU 1.25v
DDRII 2.2v at 5-5-5-15

set your memory to 2.1...you shouldn't need that much at stock speeds...2.2 is probably the max recommended...i would boost your ICH 1.05v to 1.12v and your ICHIO 1.5v to 1.60v to see if that helps...might need more umph through the chipsets to work with those drives...i had to do that with a pair of maxtor drives on my P5B Dlx.

[luihed]

8.3: in the manual, it says, "ATX power supply ready"

I checked the PSU and its fine, it was doing the same with my other PSU ( sparkle 400w)... Im actually running this comp Im using right now with the PSU I use with the Abit.....

leave it unplugged for a while.... take out battery and just let it sit.

i had a similar scare yesterday too... except i was getting 8.7 code.

Did the same and I got it to run but it was very unstable @ stock speed so I reflashed the bios ( not really smart lol ) and it worked... Got it to run fine but its not the same board cos my E67 can only do 530fsb , it did 560fsb just the day before....

This morning I fired it up and it wont boot again.... led shows 00 and pressing power doest do anything... I think Ill just RMA it and get a new one

[Magic Chief]

set your memory to 2.1...you shouldn't need that much at stock speeds...2.2 is probably the max recommended...i would boost your ICH 1.05v to 1.12v and your ICHIO 1.5v to 1.60v to see if that helps...might need more umph through the chipsets to work with those drives...i had to do that with a pair of maxtor drives on my P5B Dlx.

Didn't work. I also reinstalled the OS and drivers and still have problem.