Nvidia 8800GTS Vmods

[cowie]

I tried to do the Vmod today, it didn't go so well.

Before the vmod Vgpu was 1.26 idle and load.

Even with the resistor cranked on startup after the Vmod Vgpu was 1.65, and booted to a black screen. I removed the Vmod and it was then reading 0 voltage.

So i removed the wires to read point, installed stock cooling and all seems fine now. Very wierd.

It is a shame to as it took me forever to get my hand steady enough to make the Vgpu solder. I really don't know how you people can do it. That point is way to small.

I see on that madshrimp site it shows a pencil mode for Vgpu, anyone try it out?

did you use 1kohm vr?even a 1k "set" to 800ohms only gave me 1.31 at load if i remember correctly
i have two of the same cards no likey after 1.429 at load,blackscreen. sheez just you had to back it down abit.try again if you must(i know i would)
much to low resistance for pencil on gpu