ASUS P5K Deluxe - Intel P35 Bearlake + E6600 B1 / Q6600 B3

[C-N]

the superpis I ran are independant as well I just wait for the 1M to finish before I start the 32M one. if you notice the 8x451 run is on the 0311 bios the 9x401 is on the 0501 bios. I had trouble getting 9x401 with 0311 so that's why I used 0501.

I have never had any fsb problems with mine on either 0311 or 0501 I love this board on air it will run almost anything you can dial in.

My board & E6600 will run 460 - 475 x8 on minimum Board voltages with 0311 & 0501 it may do more but I haven’t tried.

http://s106.photobucket.com/albums/m...0MHz%20DDR1155

Regards

Craig.

[safan80]

I have never had any fsb problems with mine on either 0311 or 0501

Craig.

I didn't say FSB problems. I'm not having any fsb problems. I had a problem getting the cpu stable. I could dump 1.55volts on the cpu and it wasn't stable with 0311 but with 0501 it works fine at lower voltage.

[ChaosMinionX]

Anyone have a problem with their quadcore running 500mhz on FSB? Is it the boards problem where the POST restarts, or is that the chip? I cant seem to tell, it might be too much load on the chipset and everything. Anyone know if this sounds like a board limitation or FSB wall?

[C-N]

I didn't say FSB problems. I'm not having any fsb problems. I had a problem getting the cpu stable. I could dump 1.55volts on the cpu and it wasn't stable with 0311 but with 0501 it works fine at lower voltage.

Thats interesting to know although I haven't come across this with the ASUS my DFI 680 used to like the 8 multiplier better than the 9.

I have just flashed to 0501 perhaps I may be able to lower my CPU voltage a bit more.