Oh man, this is a massive thread. Thank you all for contibuting to all this knowledge on one single place. I have picked up a lot to try when I get home from vacation.

I have to go back to what you all refer to as the "double boot" or "endless reboot".
I understand that it is normal to have a cold boot after setting some of the OC to certain values.
I have the same thing but here's the twist:
Let's say I change the divider along with lets say the FSB above 417, then I get a double boot over and over again and IT WILL NOT STOP.
I have had it do "double boot" for an hour just because a got frustrated.
So whats the obvous solution? YES, CCMOS! But that does not work, nor does anything else.
I have tried to remove battery, pull the powercord, short the pins under the battery, keep the power off for hours. Yes I have tried it all but the board won't boot. Not until I replace my memory with a whole different kind.
I pop in one single stick of Samsung 512MB DDR-667. Get into BIOS and Load Default, then I'm ready to go.

So you could say I get endless "double boot".

Did anyone experince this and HOW did you get out of the loop?

I also got a note in "PC-Health" that say DDR18V - Fail
What is that?? It doesn't matter if I set it to AUTO or +0.550 (default for my mem)



System:
P35-DQ6 (F4)
E6600 (good for 4.05)
OCZ PC-9200 FlexXLC DDR-1150 (on water along with CPU)
HD 2900 XT