EK Waterblocks and EVGA n680i

[ranker]

Wow thanks

And there are no problems with this block and 88gtx ?

There are no problems with this block and the 8800GTX's. This was the only block with a profile small enough to fit directly under an 8800GTX. The MCW30 can also work in an SLI configuration. It doesn't fit "directly" underneath the 8800 but positions itself in a manner that it won't interfere with a WC'd 8800GTX. The EK NF4 1.1 will work with an aircooled 8800GTX unlike the MCW30. This was the deciding reason that had me replace all my MCW30's with the EK blocks (however the MCW30's are just as good).

Ranker: Are those fan gaskets attached to your PA?
What are they?

Thanks.

I use a combination of Vantec 120mm vibration dampening kits for all of my LED yates since they match well with the fan color. On my internal fans (Sharkoon Golfball 2000's), I use the black fan gasket since those fans are black. You can see some of the fan gaskets on top of the cables as I had just removed the fans and the hard drives connected to them prior to taking the picture.

http://www.evga.com/products/moreinf...1-01&family=99
i got that, not that i have watercoolign yet but im building a dedicated nb loop.(add sli8800 later?)

@malik awsome rig man! what pump is thta?


@ranker, are yo uusing the EK nb block on your sb?

That SB fan is utter trash as it's so annoyingly noising. Not in the sense of loudness but like its sound signature. Since iit's so small, it sounds very similar to the D5's whine. I took it off (15$ wasted), and put it on water.

And yes that's an EK evga 680i NB block.