i remember when the thread 1st started and everybody pretty much blamed the guy. but yeah this board is frying ram. my 10th anniversary sticks needed more and more juice as time went buy to boot up. one d9 stick needed 2.3 just to boot at ddr 6400 speeds. problem is, it gets hot and becomes unstable in the super long run.

if i shut down the comp, it would not boot unless i removed one stick, and then i would need to set it at 2.3 volts and reset all my settings, and then i need to reset the comp and lower it back to 2.1 volts. it will operate at 2.1 volts but wont boot up without 2.3 for 1 stick. so i bought a cheap set of d9's and sending my current one to RMA, if it happens again then its definatly the board.

evga said it was the ram that degrades with too much voltage, like 2.4, except i always had it at 2.0