just got a P35 DS4 up & running, so far I have tested a few bios & have found the F5C beta to be best for me...

Tried the F5D & ran into problems with OCing...

I know for a fact that the Typhoon VX fits on my DS4 so it should fit the DQ6 w/out any issues.

At least this board likes my TwinX 6400C4 rev 1.2 unlike the GA-965P DS3 board that I replaced it with.

also been able to OC my CPU & ram a bit then on my P5W DH & 965P DS3 rev 2.0...

Any tips for ram timings etc & what max volts I should be using for fsb etc??

One other thing, when I have it set to 1.45v CPU in bios, CPU-Z picks it up as 1.4v... Is Cpu-Z reporting it wrong or is the board undervolting bad??

Specs for my rigs are in my sig.

Any tips would be greatly appreciated in regards to the voltage issues...

edit: Just looked at pics of DQ6 & the heatpipe arrangement is exact same as DS4. My Typhoon VX fits like a charm... although I am thinking bout replacing it with Ultra 120 Xtreme...

edit 2: Makes me wonder why ppl would buy the DS3P when the DS4 is exact same with better cooling & is only AUD$20 dearer than the DS3P....