[First Look] DFI 680i LT NF-680i LT SLI (56K Warning~~~)

[Grinch]

Genie BIOS Settings:

Voltage Control:

CPU VID Control................ - 1.28125V
CPU VID Special Add............ - Auto
CPU Drive Strength............. - Weak
DRAM Drive Strength............ - Weak
DRAM Voltage Control........... - 2.01V
NB Voltage Control............. - 1.44V
SB Voltage Control............. - 1.56V
SB Dual Voltage................ - 1.52V
LDT Voltage Control............ - 1.22V
CPU VTT 1.2V Voltage........... - 1.21V
GTL REF Voltage Control........ - Disable


FSB & Frequency Seting:

FSB-Memory Clock Mode.......... - Linked
FSB-Memory Ratio............... - Sync Mode
FSB (QDR), MHz................. - 1600

=====

PCI Bus, Slot 1 MHz............ - 100
PCI Bus, Slot 2 MHz............ - 100
SPP <-> MCP Ref Clock, MHz..... - 200
LDT Frequency.................. - 5x
CPU BSelect.................... - Auto
CPU Clock Ratio Unlock......... - Enabled
CPU Clock Ratio................ - 8x


CPU Feature:

PPM Mode....................... - Native Mode
Limit CPUID MaxVal............. - Disabled
C1E Function................... - Disabled
Execute Disable Bit............ - Enabled
Virtualization Technology...... - Enabled
Core Multi-Processing.......... - Enabled

Memory Timing Setting:

Memory Timing Setting.......... - Expert
CAS Latency Control (TCL)...... - 4
RAS# to CAS# Delay (TRCD)...... - 4
Row Precharge Time (TRP)....... - 4
Min RAS# Active Time (TRAS).... - 12
Command Per Clock (CMD)........ - 2T

=====

Bank To Bank CMD (TRRD)........ - 3
Row Cycle Time (TRC)........... - 22
Write Recovery (TWR)........... - 5
Write -Read Commad............. - 9
DRAM Refresh Rate.............. - 7.8uS


not that this is a BIG overclock...just wanted to share where I am 100&#37; stable right now...here are my temps:

Cpu-Z Shot: