Pedro,

I ran my memory in both the orange and yellow slots and checked bandwidth in Everest and SiSoft... here are my results.



Comments:

  • Strangely, I could not get the board to POST with the RAM running at 1T in the yellow slots.
  • At 1100MHz running 2T command rate, there was no difference between the yellow and orange slots with my memory. What am I missing?
  • Oddly, when switching RAM between slots, the board requires a CMOS clear to POST. Then after adjusting settings (loading from cmos reloaded profiles for example) and rebooting, it would hang on POST code #75 for 2 minutes before rebooting normally. I'm not sure why it does this, any thoughts?.
  • 1T is marginally faster at 800MHz than 2T at 1100MHz (at least according to Everest... Sisoft Sandra has 1T slightly slower).