Quote Originally Posted by ranker View Post
That's where mine is sitting right now. I haven't had time to play with it but I'm gonna have a hard time just getting the tubin right. My Iwaki-RD-30 is going to pump into the PA120.2 mounted in the back with the barbs facing down. From there, the PA120.2 will curl between the mobo tray and the HD racks hanging from the PA120.2 to it goes up and over the mobo tray into my new Apogee GTX I just purchased.

I'll finalize the tubing tonight I hope. However, I'm really interested knowing if the meanwell PSU's mount perfectly in the secondary PSU holes cut out for the U2-UFO's.
ranker, id be very very careful about that rear PA. I noticed really quickly that i couldnt do a push/pull config on my MCR220. If i also recall correctly, a PA +120mm fans = MCR220 + push/pull fan config in size.

In other words, You might not be able to fit it because your hard drives will cram up hella close to your 5 1/4 bay. Or worse case scenario, you'll only be able to mount 2 hard drives at the lower section.

Yeah, i wanted push/pull config on my MCR220, but, as i said, i had to improve a lot when building her.