Hi all, my 1st post in this thread since following its conception. I have a early revision board and use corsair xms2 6404v1.2 D9s with a l624a and have always been able to post with manual memory settings upto 390fsb although unstable with orthos and only stable at 3.33ghz. Temps after the system had been on for a few hours browsing etc where between 36-41c, room temps about 20c and under load would never go above 52c not that impressive considering my w/c setup(as per sig).However today I managed to get hold of a l644g380 was wary of these chips as I had heard that they not the best of batches, but it appears I have got a better than average one , I can now boot into window 400fsb using 1.4875vcore and it is stable running games, encoding etc, however it craps out in orthos after 5hrs blend priority 9,sometimes with an error and sometimes just plain reboots? Temperatures now are incredibly low compared to my original chip, idling low 20s and under load 40c room temps where 22c so this is a definite improvement in 1 area and this is unlapped, unlike my last chip which was lapped! My question is how far would you raise the the other voltages safely? I have removed the heatsinks applied AS5 and have fitted 40mm akasa fans to the NB and SB, chipset temps never go other 39c. Ram has active cooling aswell.
Reply With Quote
Bookmarks