Quote Originally Posted by awhir View Post
huys need help.

im at 450x8 and cant get past with out been unstable.

any ideas to get it passed 450 at 8.the board will go past 450 with lower multi.so it most probley the chips max.

Code:
Genie BIOS Setting

NB Strap Select :auto
Exit Setup Shutdown Mode2
CPU Clock Ration 8 X
CPU Clock 450
Boot Up Clock Auto
DRAM Speed 533
PCI Clock 100
Auto Detect PCI Clk Disable
Spread Spectrum Disable

CPU Feature

Thermal Management Control Disable
Limit CPUID Maxval Disable
PPM Function Disable
C1E Function Disable
Execute Disable Bit enable
Virtualization Technology disable
Frequency Nolimit Disable

Voltage Setting

CPU Voltage Setting +225.0mV (1.5v)
DRAM Voltage Setting 2.200V
VTT Voltage Setting 1.19 V
NB 1.25V Setting 1.40V
SB 1.5V Setting 1.5V
SB 1.05 Voltage Setting 1.05V

DRAM Timing

DDR Configuration: Mode 3
GTL+ Driving Strength Mode2
Enhance Data Transmitting Fast
Enhance Addressing Fast
DQ Calibration :Auto
Channel 1 CLK fine delay Auto
Channel 2 CLK fine delay Auto
CAS Latency Time (tCL) 4
DRAM RAS# to CAS# Delay (tRCD) 4
Precharge dealy (tRAS) 15
All precharge to Act Auto
REF to ACT Delay (tRFC) Auto
MCH ODT Latency Auto
Write to PRE Delay (tWR) Auto
Rank Write to Read (tWTR) Auto
ACT to ACT Delay (tRRD) Auto
Read to Write delay (tRDWR) 8
Ranks Write to Write (tWRWR) 6
Ranks Read to Read (tRDRD) 6
Ranks Write to Read (tWRRD 5
Read CAS# Precharge (tRTP) Auto
Try my bios settings a few posts back. Our rams may be somewhat similar. I really don't think you need to adjust your GTl, auto should be fine. My memory settings may be a bit tight so try 4-4-4-12-3-21-2-11-10-2-8-6-6-5-5-3