QuadGT Arrived (56k warning)

[Hardc0r3]

someone can you help with something
i wanna replace the TIM on the MB and SB and PWM area, most recomended Ceramique, Got one.

How do i use the the TIM, i just lay it on all the surface of the PWM area heatpipe sink ?, how thick it should be? how do you put it back on,
first the PWM area and then the NB in order to make proper contact? , how do you know if it makes good contact, before starting youre system, can you see some how?

need help , sure would be nice to have a guide as asus p5wdh does, from people who already did that and reported succes, because reading this thread i saw also many failed, to do it right from the first time