Kinc found a picture on his USB flash drive

[GLENBOY]

Sorry I ment without the coldplate. The waterblock I am using covers the shim around the gpu wich is slighty higher then the die. I did a test where i first tightend the bolts like I usually do and wasnt quite happy with the contact. I tested too tighten a bit more (I stopped when the pcb started to bend ), and the contact was as good as ever. I am still recomendng you to use a coldplate so you minimize the risk of dmaging the card.

thanks kinc i have been looking all over for some 1 mm copper sheet with no luck so hopefully i'll get away with not using one, i know your busy but i appreciate you taking the time to answer, a pair of these should work well in my old p5w-dh , thanks again, you're still the man Oh on a side note would you recommend using ram sinks on the upper side of the card as well,as the ram chips are on both sides on these or is this not really neccessary with these thanks