With Vcore at 1.45 which is the max I want to go for now
Vmch 1.55
Cpuvtt 1.40
Pcie 110
DDR2 2.35 (OCZ warranties up to this) and running loose timings for now till I hit my CPU sweet spot. 5-5-5-15 2T

Cooling with a slightly used amanda titan, HR-05 SLI on NB, and Swiftech BGA sinks on mosfets. (more on that below)


So far with a new QuadGT and a 6700 with OCZ 8500 DDR2 2x1GB I have booted into Vista at 510x7 but not orthos stable. I haven't tried over 510 as I am looking for stability. I did 500x6 orthos stable for 15 hours at 1.45 Vcore but thats too slow CPU speed for me. 500x7 was also not orthos blend stable. I may get it stable in the 480s at 7 multi but I will have to test. It looks like 8 multi and mid 450s FSB is where I will wind up.

I have posted at 510x8 on air which is unstable.

Right now I am testing at 445x8 so far orthos stable 30 min and counting as I type this. Once I get cpu stable then I will tighten ram as I think this ram can do a lot. Maybe I will try more then 1:1 as I have read people taking it over 1100 but we shall see. I think I would rather have really tight timings on 1:1 then looser timings at higher freq.

Heres my main problem. The PWM's are really hot. My temps at load are hovering at 120C according to Uguru. Thats the middle ones, the ones on the edges are 20C cooler. I don't think I made a good choice with the Copper sinks. If I wasn't lazy I would add a fan to them but there lies the problem with the Titan Amanda. Anytime you need to remove it, its like re-building your entire system as the Mother board has to come off the tray

I have a Silverstone TJ09 case with 2 fans as exhaust at the top. I may turn the one closest to the mosfets around and see if that helps even though its not exactly right on them. When I get a stable OC I will post some screens