Quote Originally Posted by Lome View Post
recomend you measure the volts with dmm cause nothing in the bios comes very close to whats realy going on the atleast on mine
what revision is your board..mine is board is 505..loaded with bios 2333

look back on my early posts on this issue, the sensor on my board is way off too.....Gtj boards have better sensors than mine

My bios reports an idle vcore of 1.535v when set to 1.525v with powerslope on....2 separate DMMs read 1.50 idle and load 1.50v(after 24hrs of P95)

my vdmm measured at 2.01v(I can recall no if this was idle or load voltage) for 2.0v setting in bios(the bios doesnt report this value at least not where i have seen...so this was odd that it delivers the voltage I set when vcore did not)

BTW I have installed the OS, if I install the marvel drivers now will I be able to use eSATA???