Quote Originally Posted by nealh View Post
Thanks gave this a try..the Corsair HX620..has cables are black..so I found a molex that was unused from a fan in my case

BIOS setting 1.525v bios reads 1.535...DMM check 3 of the squares..1.39-1.42v!!!..still not sure if this correct(in winxp at idle...not I have RMclock with C1e disabled and disabled in bios C1E and EIST..using bios 2333

Blah...I reset bios to optimal defaults and turned off C1E/EIST...stock idle vcore is 1.16v....load was the same

I checked my DMM on some batteries..AAA 1.5v..reads them fine

other than 2333 bios what would you guys recommend ..2507?
Make sure that you're measuring on the CPU side of the blue or black power chokes. Measuring on the side closest to the blue heatsinks will give you inconsistent results because you're measuring before the filter. The 1 in the upper left corner is the only one that's safe to use because the rest all have caps right next to the outputs. Check the voltage section of the guide for pics.

In Everest the core voltage is clearly marked CPU Core on the Computer/Sensor page not to mention the OSD. If you don't see voltages or fans then you're using an older version.