Ok, hopefully I have a cure for your pain. Please follow these steps exactly, as they allowed me to set it exactly as you want it.
1. Power down, and place EZ-Raid jumper in center position.
2. Clear cmos. (Important as per page 5-50, If jumper is not changed upon first installation the system applies the default setting of RAID-1.)
3. Connect your two raptors on the top two ICH7 SATA ports.
4. Connect your optical drive to the orange EZ-Raid SATA port on the right hand side.
5. Do not connect your Data HD as of yet.
6. Power up.
7. Enter bios, select Advanced page -> DH Feature page -> Enable EZ Raid Mode change.
8. Reboot.
9. At message press F1.
10. Enter bios and set up as per your normal routine. (Don't forget to enable your Raid. Save and Exit.
11. Power down.
12. Connect Data HD to the remaining ICH7 SATA Port.
13. Power up.
14. You should have success, because I did. If not RMA.
15. Smile.
Reply With Quote
Bookmarks