RD600 first look and general questions

[dasa]

still having some minor stability problems that i have to track down (orthos has been failing sometimes and i have been getting 1 error in memtest86 test6) but its getting there

3dm06 12435 http://service.futuremark.com/compare?3dm06=1623902
3dm01 59729 http://service.futuremark.com/compare?2k1=9178957

temps have been getting higher than id like might have to try clean the water loop and remount at some stage
http://i3.photobucket.com/albums/y83/dasa09/oc1.jpg
http://i3.photobucket.com/albums/y83...9/P1050726.jpg


i think this is fairly close to what i had it running in the above tests
>Performance options

Memory Clock Frequency: DDR-400
Control CPU Frequency: Manual
x CPU Frequency (Mhz): 400
PCI-E Overclock: 145


>Memory Timing Menu

CS Output Timing: Delay 1/4 clock
Dual channel Split Mode: AUTO
ADDR/CMD Driving Strength: 15
Address/Command Timing: 1T
Memory Timing Select: Manual
CAS Timing (TCAS): 3
Read RAS-CAS Delay (TRCDR): 3
Write RAS-CAS Delay (TRCDW): 2
RAS Precharge Time (TRP): 3
Cycle Time (TRAS): 8
Row Cycle Time (TRC): 4
Refresh to Active (TRFC): 30
Bank to Bank CMD (TRRD): 3
Write Recovery (TWR): 3
Read-Write Command (TRTW): 3
Write-Write CS (TWTW_CS): 2
Write-Read Command (TWTR): 3
Write-Read CS (TWTR_CS): 2
Read-Read CS (TRTR_CS): 2
Read Data Transfers: 4

CPU Vid Control: 1.54v
CPU VID Special ADD: Auto
DDR2 Ram 1.8 Voltage: 2.39v
CPU VTT 1.2V Voltage: 1.23v
NB Core 1.2V Voltage: 1.48v
NB PLL 1.8V Voltage: 2.21v
NB PLL 1.2V Voltage: 1.38v
NB PCI-E 1.2V Voltage: 1.34v
NB Core 1.2V convert from: 2.14v
SB Core 1.2V Voltage: 1.34v
Clockgen Voltage: 3.40v
Conroe P-State Multiplier: x9
C1E Function: Disabled

Dasa:
I asked about those ancillary voltages as well and was told the board is onew no one relaly knows but NB PLL 1.8v =2.03 was ok...unfortunaltely beyond that I have no idea

ok thanks nealh