thanks for the tips... based most of my mods on this article...
heres my antec 900 modded...
powder coated without mod:
parts disassembled again, holed and powder caoted the mounting plate again.
the reversed hdd's with a slight hole mod to accept sata cable that isn't 45degrees.
did some wiring extensions to accomodate for the need of a longer 12v rails. and the front audio support. all laid at the back side of the case. i have rounded cables but decided to use the flat one as it gave a cleaner finish.
finally the final look of the interior...
front look:
hope you liked it. the holes were cut using dremel and a jigsaw, which i found easier and straight to use. filed and after the powder coat, the corners of the cuts were very much rounded thus removing the need for additional insulations.
looking to mod my case some more, probably the front area.
this certainly is not an easy mod, but heck, half the look is the work placed on it. it gives a certain sense of accomplishment... makes you feel good!
Reply With Quote
Bookmarks