Quote Originally Posted by hotchoc View Post
4. vMCH/ICH = northbridge right? What's the optimal voltage to do so ? What's the danger level as well ? What i did in my previous P5B Deluxe mobo is to set my vMCH as default and to increase my frequency bit by bit. Eventually when the CPU frequency maxed out on the max vcore level say 1.5 V, i will then slowly increase the VMCh followed by the CPU freq/voltage. Is this the correct way you guys do it?
5. What about the vFSB ? Which part does it control again and what's the safe range for it ?

p.s. What type of orthos tests i should be running ?
4. Just leave it at default value as you stated. For 300, you don't need a lot.
5. Same thing. Leave it close to default.

As for orthos, I like to do blend now for at least 10+ hours but small is good too. Others say large is best for C2D (not sure though).

if you want to be completely thorough, you could always do like 8 hours of each.

For me though, I did orthos blend for 8 hours last time i checked and I have had zero crashes, bsod's since I had my bad axe 2 setup.