Laing DDC (Swiftech MCP350/355) Names & Info

[Hard H20]

All,

I'm starting to get a bit concerned with the DDC+ failures that I'm seeing at different forums, as I understand it the % of failures is very low but it still concerns me when I think about it. I work away from the house quite a bit and I would hate to come home to a fried system due to pump failure.

I'm getting ready to build a dual loop with 2 MCP355's w/ Petra's Tops. Would the increased heatdump be of any concern if I ran 2 additional pumps on each loop in series for safety? I think it very unlikely that both DDC's would crap out at one time.

What is you're opinion XS, 2 pumps on each loop in series or stay with 1 pump per loop?

[IanY]

All,

I'm starting to get a bit concerned with the DDC+ failures that I'm seeing at different forums, as I understand it the % of failures is very low but it still concerns me when I think about it. I work away from the house quite a bit and I would hate to come home to a fried system due to pump failure.

I'm getting ready to build a dual loop with 2 MCP355's w/ Petra's Tops. Would the increased heatdump be of any concern if I ran 2 additional pumps on each loop in series for safety? I think it very unlikely that both DDC's would crap out at one time.

What is you're opinion XS, 2 pumps on each loop in series or stay with 1 pump per loop?

I have redundant pumps in all my loops. All my loops have at least two pumps. That's the best way to ensure you don't have expensive dead hardware. I encourage you to do so. If you run out of space, there's an Alphacool dual pump adapter that I use.