Commando Results by Tony and Andre (and others...)

[iviustang50h]

Even though the commando is based on the P5B-Deluxe i wouldnt just use the same bios settings recommended for that board. Also that thread by fcg was a general guideline for you to get up and running and he never intended for people to use those settings 24/7.

Give us some more info and hopefully we can help. What are you individual settings. Voltages, bios version, etc etc.

Sorry, I should have clarified. I turned off the same thing he did if my bios had them; that's what i meant when I said I "copied" his settings. I didn't use his voltages.

When overclocking my settings were:

Using Bios 803
Spread spectrum - off
PCI clock sync - 33.33
PCI express frequency - 100
DRam - 1:1 (533)

CPU Vcore - 1.45
FSB Voltage - 1.4
NB Vcore - auto
Memory voltage - 2.3 (per G.Skill specs. I have the DDR1000 stuff rated at 4-4-4-5)
DDRII Channel A, B and Ref voltage - all 3 at auto
SB Vcore - 1.5
SB Chipset Voltage - auto
ASUS C.G.I. - auto
Static read control - auto
Cas Latency - 4
Ras to Cas - 4
Ras Precharge - 4
Active to Precharge - 5
Write recovery time - 6
DRAM TRFC - 42
DRAM TRRD - 10
Write to Read - 10
Read to Precharge delay - 10
Write to Precharge delay - 11

CPU ratio CMOS setting - 9
C1E - disabled
Max CPUID Value - disabled
Vanderpool Tech. - disabled
PECI - disabled

Sorry for the long list, but I want to get this issue fixed.

Is it possible the Tuniq tower is incorrectly installed? I followed directions perfectly and hand tightened the screws until I almost couldn't turn them any more. Is that too tight? Oh, and the fan is inside the tuniq tower is facing the rear of the case so it blows the air out the back. Is that correctly installed?

Thanks!