P5W DH vdroop with pen instead of pencil?

[GFORCE100]

1) Use a 2B pencil
2) Are you sure you're..."painting" the right resistor ? ( show us which one you're drawing )
3) I assume that you're measuring your Vcore @ idle & full load with a DMM ( Digital MultiMeter )

1) So the lead should be softer rather than harder? I was under the impression if the lead is softer it won't stick as well to draw a line between both points. I'll rub the lead off and use a 2B pencil then.

2) I'm at work now hence can't upload a photo. But it's the one shown in already existing photos, very near to the left DIMM slot. I'll upload a pic later.

3) No, I was looking at what Lavalsys Everest reports as even if it's not accurate, it should change after the vdroop mod right?

P.S Why are you so against the P5W DH and other Asus boards?