Quote Originally Posted by cursivearmy1
I will do this on my ninja with the danger den kit from petra's if my e6700 buy works out.
You may also want to consider this:

http://www.petrastechshop.com/ekcpuwamoha.html

I just purchased the Danger Den Kit and the EK. The springs on the EK kit are quite a bit thicker than the DD's

The 4mm pan head screws are a bit long, (45mm), for the Infinity, so I replaced them with 35mm ones. You could probably add spacers under the motherboard or just cut off 5-10mm's.

I used some nylon and steel washers on the back and steel washers under the springs to finish up. The 4mm nut was added as a jam nut.