GIGABYTE DS3 FAQ by CrazyJohn /FAQ on 1st page/

[geof]

9x
enabled
400
100
diabled
2.00
800
manual
4
4
4
12
auto
auto
auto
0
auto
normal
+0.2 vdimm
+0.1
+0.1
+0.2 MCH
1.5000
1.325
auto

Ive have placed a fat north bridge heatsink on the nb, and also 2 silent fans on the nb heatsink and south bridge. That helps alot ...

i'll try this , thanks a lot !

[slatr]

My DS3 board and 6400 should be in tommorow. I am getting 2 gbs of the Gskill Hz ram.

If the board does boot up with one stick, I do need to change dimm to +.3 to give it 2.1v, right?

I also have a fortron power supply, crossing fingers.

[MonkSP]

My DS3 board and 6400 should be in tommorow. I am getting 2 gbs of the Gskill Hz ram.

If the board does boot up with one stick, I do need to change dimm to +.3 to give it 2.1v, right?

I also have a fortron power supply, crossing fingers.

Its strange but with BIOS F4 Oficial and vdimm auto, easy tune reads 2.1v!

[slatr]

Thanks Monk

My backup plans are cheap memory to boot up and update the bios and a new power supply.

UGH I don't want to spend any more money right now, I hope I need neither

[geof]

Its strange but with BIOS F4 Oficial and vdimm auto, easy tune reads 2.1v!

speedfan reads 1.9v ... ( 1.8v with others bios )

[Ruhnie]

speedfan reads 1.9v ... ( 1.8v with others bios )

Where in Easy Tune does the vdimm display? Or do I need to d/l speedfan to get an accurate reading?

[harbin]

Its strange but with BIOS F4 Oficial and vdimm auto, easy tune reads 2.1v!

Yes, I have the same thing here.

[geof]

My DS3 board and 6400 should be in tommorow. I am getting 2 gbs of the Gskill Hz ram.

If the board does boot up with one stick, I do need to change dimm to +.3 to give it 2.1v, right?

I also have a fortron power supply, crossing fingers.

no pb here with a Fortron epsilon 600W