GIGABYTE DS3 FAQ by CrazyJohn /FAQ on 1st page/

[Ribbon]

Ribbon have you tried lowering your multiplier to 8x, just to see what happens?

You can change the divider in the same section where you change your multiplier, vcore, and all that jazz. It's probably set to auto. You'll know when you find it because when you toggle it, your memory speed in that same screen will change (sorry I'm being lazy but I know it's there). Also of course make sure that PCI-E is set to 100 and not auto.

I really think that its your board being finicky. I'm not running at 400 FSB and my timings are 5-5-5-18, but I wouldn't worry too much about that last timing being a bit high since Conroe doesn't seem to respond too much to lower timings anyways. Also, make sure you are running at least +.1v on the RAM, since the board defaults to 1.8 and that RAM is 1.9.

Yeah, my Vdimm is +0.2v and my PCI-e is 100. I'll just leave my RAM timings on auto.

My computer won't post past 370x8 (2960MHz). This is really starting to annoy me..

Advanced BIOS Features
Limit CPUID Max. to 3: Disabled
No-Execute Memory Protect: Disabled
CPU Enhanced Halt (C1E): Disabled
CPU Thermal Monitor 2(TM2): Disabled
Virtualization Technology: Disabled

Integrated Peripherals
USB Keyboard Support: Disabled
USB Mouse Support: Disabled
Azalia Codec: Disabled
Onboard Serial Port 1: Disabled
Onboard Parallel Port: Disabled

MB Intelligent Tweaker (M.I.T.)
CPU Clock Ratio: 9x
CPU Host Clock Control: Enabled
CPU Host Frequency (Mhz): 356
PCI Express Frequency (Mhz): 100
C.I.A. 2: Disabled
System Memory Multiplier: 2.00
DRAM Timing Selectable: Auto
Memory Performance Enhance: Normal
DIMM OverVoltage Control: +0.2v
PCI-E OverVoltage Control: +0.1v
FSB OverVoltage Control: +0.1v
(G)M.C.H.: +0.1v
CPU Voltage Control: 1.5v
Robust Graphics Booster: Auto