FX-60 0536RPMW meets Kayl Black Frozen SS

[s7e9h3n]

http://www.techpowerup.com/articles/...s/NF4LD329.zip

Try that one...should give them all to you Now I'm ready to see some REAL times

[realsmasher]

one question :

different checksums at dualcore 32m pi... is that normal ?

[s7e9h3n]

one question :

different checksums at dualcore 32m pi... is that normal ?

A checksum is unique for each particular time that results from a finished run

[Fosco]

Nice FX60 there eva2000

Yust hooked up my FX60 , CCB2E , 0536WPMW.
Cooling is modded Mach2 r507 by Overklokk.
On DFI NF4 Ultra-d , with OCZ 600W and 2x1024mb Corsair XMS.

Time sucks , yust checked fore 32M stability, will work on the time later.

[eva2000]

thanks guys... nice clock Fosco need to work on those times though

Question why is the cold bug only freeze in windows and not memtest ???? I can memtest my FX-60 fine at 12x250mhz 2-2-2-5 fine without freezing or errors but windows will freeze ?

Is it cause in windows idle.. the cpu temps can be alot lower than in memtest ?

seems the extent of the cold bug on FX-60 for me is

- can boot into windows upto 233HTT so far and if i keep windows under load can bench at 233HTT
- tried 244HTT and can boot as far as windows welcome screen then freezes there
- as far i have tested 220HTT is where i'm okay so with 406BTA bios i have access to 216/250 dividers at certain cpu multipliers and know at 15x cpu multiplier so far i have access to 216/233/250 uplock multipliers so can ram up my memory clocks keeping HTT low.

Testing the upclocks now in memtest @15x220HTT with 233 divider... memtest says 220mhz mem but guess it doesn't show mem's upclock ram speed until i get into windows. I estimate i'm at 256mhz 2-2-2-5 since memtest reports 2930MB/s bandwidth and for dual core cpu it reports lower bandwidth than single core san diegos and venices so probably about right.

Strange with DFI NF4 UT SLI-DR R.AB0 and 406BTA bios at cpu multiplier 14x i only get to choose 216 and 250 dividers, at 15x can choose 216, 233 and 250 ?



edit: Okay after flashing to 406BTA bios i managed to get upclock dividers in play. The difference in super pi times is very noticeable i.e.

Super Pi v1.50

FX-60

3416Mhz (17x200HTT)
DDR400 divider
200mhz 2-2-2-5 memory = 22min 36.343s

vs

3300Mhz (15x220HTT)
DDR466 upclock divider
253mhz 2-2-2-5 memory = 22min 20.703s

Okay Sandra 2007 Lite must have a bug as it must think my FX-60 @15x220HTT DDR466 upclock with mem @253mhz 2-2-2-5 is an intel DDR2 system as it's reporting crazy buffered and unbuffered bandwith over 11k and 4k respectively! LOL

Buffered


Unbuffered