Anyone who has had SDS with DFI nF4 please respond

[ionicle]

Questionaire

1) In or Out of a chassis? (If in chassis, type of standoffs)

both, and just standard ones that came with the case

2) 4 lights or 3 lights on when dead?

both

3) 5V or 3.3V Vmem jumper position?

3.3

4) What was Vmem set to?

2.9

5) What was Vcore base voltage set to?

1.55

6) Were you using VID special? If so, what % setting?

no

7) What was Vcore startup voltage set to?

1.55

8) Type of memory used at the time? (TCCD, BH-5, UUT, etc.)

TCC5 - OCZ PC-3200 EL Platinum Revision 2 (2x512MB)

9) FSB setting at the time?

225

10) Multiplier in use at the time?

x12

11) Processor type in use at the time (i.e. 3200+ Winnie or FX-55 or 3200+ NewCastle or Venice or ???)

4000+ san diego

12) What was the last thing you did just before it croaked? (Changed VMem, Vcore, lost your lucky rabbits foot, ???)

nothing, just froze while booting up, and in windows, and in several other stages of booting up, including the windows blow lines going across forever, it was 2 hours of it before i realised there was a problem LOL

13) Did you notice if the Vmem good LED was lit (between DIMM slot 2 and 4-pin 12V cnx)

it was

14) Air, water, or phase-change on the CPU?

Air, XP-120

15) MB jumper position settings (any you remember)

standard?

16) What else was hooked into your system (PS2 mouse, USB this, PCI that, Gfx card)

usb mouse, keybord, speakers, moniter, webcam, and microphone, also lan

17) Power supply make/model being used?

Hiper 580W Modular

18) Did you notice if the Standby Power LED was lit after it died (just to the right of the diagnostic LEDs)

no, it wasent

19) Did you have all of the MB power connectors hooked up?

one time i didnt, but the others i did


helpfull?