***Official***Z68X/P67A-UD7 Club/Discussion/Info**

[maxxx]

I would take down blck like already said, or i would check your temperatures. When i had a clodbug problem that was my stop code. That can also indicate not enough vcore, or cpu pll not right(increase/decrease) you might need to increase cpupll try 1.89 first. Also i know this applies to the UD4 you need to use turbo mode and enable tdp and tdc to 300, idk if you have to do this on the UD&, I am going to test it would, but on other boards it seems to keep back max oc.

@sin0822: thanks for the reply mate. I am trying the bclock route but once I go over 54x100 (eg. 54x101), I get that "4E" error. I don't think heat is my problem as its running on a custom Boreas (TEC). Let me try those settings from the UD4. Crossing fingers...