Quote Originally Posted by Bojamijams View Post
I agree about that alachesu but the charts are quite misleading then... it shows it giving double the flow of the other tops.. now the other tops are going to have that flow all throughout the loop.

3.47 will never happen throughout the loop, just at the exit and then immediately split it in half (ie. performance through the loop will be exact same as all other tops)

Except now you're using the warm loop to heat up the cold loop..

so.. what am I missing here? I don't see the point
Check the flow for each flow branch. You actually get a flow increase for the CPU/GPU branch compared to the serial setup. The T3 is basically a convenient way to run parallel loops with a slight tweak to improve high flow performance of the pump.

And I agree, the total flow bar is some what misleading, but if you actually think about what you are looking at I'm sure most people can figure it out