Quote Originally Posted by Bail_w View Post
Did you use floppy or usb method?
I actually have a few floppy drives and disks lying around still so I just did that.

Quote Originally Posted by CaptMorgan View Post
Ok my Sammy(s) build has been forever in the waiting-life has its bumps sometimes. anyways I am setting up the board, drive and PSU on a nice clean shelf so I am going caseless. After doing some reading which metal prongs at the bottom of the board i am supposed to touch together with say, a screwdriver, to jumpstart the board? I tried last night a few times had the lights on the board once I had it plugged in; but the lights seemed to flicker on and off. Now I figure i am doing this all wrong. Also I am going to setup another board and all the components just to make sure it is not any of the parts.
Just to double check I have a bunch of 2gb and 1gb for all my boards-if for now I am only placing 2 of each( of course just the same number) which slots would they go in?
Thanks guys
Here this pic should help, I went poking around on the board with switches and LEDs



According to the manual for this board, you fill from top down. So I'd put two 2GB in the first two slots and the next two slots put the 1GB.