X48 Rampage Formula Preview.

[Fritz_the_germ]

Yo Alien Grey,
thank you for the LinX link.
I ran 20 loops LinX "all" without errors with these settings:

BIOS@0902-Settings of the Maximus@Rampage
CPU Feature

Ai Overclock Tuner [Manual]
OC from CPU Level Up [Auto]
CPU Ratio Control [Manual]
Ratio CMOS Setting: [9]

FSB Frequency [450]
FSB Strap to North Bridge [400]
PCIE Frequency [100]

RAM
DRAM Settings [Manual]
DRAM Frequency [1.200MHz]
DRAM Command Rate [2T]
DRAM Timing Control [Manual]
DRAM CMD Skew on Channel A [Auto]
DRAM CMD Skew on Channel B [Auto]
DRAM Clock Skew on Channel A [advanced 250ps]
DRAM Clock Skew on Channel B [advanced 300ps]

CAS# Latency [5]
RAS# to CAS Delay [5]
RAS# Precharge [5]
RAS# Active Time [15]
RAS# to Ras# Delay [Auto]
Row Refresh Cycle Time [Auto]
Write Recovery Time [Auto]
Read to Precharge Time [Auto]
Read to Write Delay (S/D) [Auto]
Write to Read Delay (S) [Auto]
Write to Read Delay (D) [Auto]
Read to Read Delay (S) [Auto]
Read to Read Delay (D) [Auto]
Write to Write Delay(S) [Auto]
Write to Write Delay (D) [Auto]

DRAM Static Read Control [Enabled]
Ai Clock Twister [moderate]
Transaction Booster [Manual]
Common Performance-Level [6]
Pull-In CHA PH1 [deaktiviert]
Pull-In CHA PH2 [deaktiviert]
Pull-In CHA PH3 [deaktiviert]
Pull-In CHB PH1 [deaktiviert]
Pull-In CHB PH2 [deaktiviert]
Pull-In CHB PH3 [deaktiviert]

Voltage Settings
CPU Voltage [1,30625V]
CPU PLL Voltage [1,54V]
North Bridge Voltage [1,33V=1,35V real]
DRAM Voltage [1,80V=1,89V real]
FSB Termination Voltage [1,24V=1,16Vreal]
South Bridge Voltage [1,05V]
Loadline Calibration [Enabled]

CPU GTL Reference [0,63x]
North Bridge GTL Reference [0.67x]
DDR2 Channel A REF Voltage [Auto]
DDR2 Channel B REF Voltage [Auto]
DDR2 Controller REF Voltage [Auto]
SB 1.5V Voltage [Auto]
CPU Clock Skew [Delay 100ps]
NB Clock Skew [normal]



The highest temp on both cores was 79°C which made me a little shaky.

Cetero censeo:
I can´t get my system stable at a memory speed faster than 1,200 MHz.
No matter what I do