hi there lads, im not an actual RF owner, but i do have its bios modded to my P5Ebios is RF0410. ok, so straight to the point... i was just wondering how i could set tREF values in bios instead of having to set them with MemSet 3.4 in windows. any clues? i thought that extreme tweaker was the right setting to do the trick, but the other day i proved myself wrong... the strange thing is that when i had my SuperTalent (cheap ass) memory, i allways had tREF at 16383T while on "Stronger" extreme tweaker setting.. but now, with my g.skill set i find that i would only get 3120T when in OS. "strange"
i thought, "but hey, dont give up!" and so i ended up here...
hope this helps:
Code:Extreme Tweaker Ai Overclock Tuner : Manual OC From CPU Level Up : AUTO CPU Ratio Control : Manual - Ratio CMOS Setting : 7 FSB Frequency : 458 FSB Strap to North Bridge : 333 PCI-E Frequency: 105 DRAM Frequency: DDR2-1100 DRAM Command Rate : 2T DRAM Timing Control: Manual CAS# Latency : 5 RAS# to CAS# Delay : 5 RAS# Precharge : 5 RAS# ActivateTime : 15 RAS# to RAS# Delay : Auto Row Refresh Cycle Time : 50 Write Recovery Time : Auto Read to Precharge Time : Auto Read to Write Delay (S/D) : 9 Write to Read Delay (S) : 4 Write to Read Delay (D) : 6 Read to Read Delay (S) : 4 Read to Read Delay (D) : 6 Write to Write Delay (S) : 5 Write to Write Delay (D) : 7 Write to Pre Delay: 14 Read to Pre Delay: 5 Pre to Pre Delay: 1 All Pre to Act Delay 6 All Pre to Ref Delay: 6 DRAM Static Read Control: Enabled Ai Clock Twister : Stronger Transaction Booster : Manual Common Performance Lvl: 7 Pull-In of CHA PH1: Disabled Pull-In of CHA PH2: Disabled Pull-In of CHA PH3: Disabled Pull-In of CHA PH4: Disabled Pull-In of CHA PH5: Disabled Pull-In of CHB PH1: Disabled Pull-In of CHB PH2: Disabled Pull-In of CHB PH3: Disabled Pull-In of CHB PH4: Disabled Pull-In of CHB PH5: Disabled CPU Voltage : 1.375000 CPU PLL Voltage : 1.5 North Bridge Voltage : 1.51 DRAM Voltage : 2.0 FSB Termination Voltage : 1.36 South Bridge Voltage : 1.10 Loadline Calibration : Disabled CPU GTL Reference : 0.67 North Bridge GTL Reference : 0.67 DDR2 Channel A REF Voltage : Auto DDR2 Channel B REF Voltage : Auto DDR2 Controller REF Voltage : Auto SB 1.5V Voltage : 1.55 CPU Spread Spectrum : Disabled PCIE Spread Spectrum : Disabled Advanced CPU Configuration CPU Ratio Control : Manual - Ratio CMOS Setting : 7 C1E Suppport : Disabled CPU TM Function : Disabled Vanderpool Technology : Disabled Execute Disable Bit : Disabled Max CPUID Value Limit : Disabled
many thanks in advance for any piece of advice anybody can provide
Reply With Quote
Bookmarks