Official DFI LanParty UT X38-T2R(and LT) Discussion/Review/Overclock/Guide Thread

[zsamz_]

Oh, so you think it's not the board but my unproper hands?
It makes me hope

To be honest I didn't try any GTL or other tweaks. Only voltages were changed from default settings, all other was in auto. Ok, I'll try GTL and other things.

You know, I have one more problem - with the memory.
I have quite good 4x1Gb sticks with D9GMH, 8-layer PCB. But they want to run 1200 only with 2.3v, and even at this voltage they are not fully stable.
Also as I know many of them (CSX) may run 1200 fully stable only at 2.1v.
But here I've tried alot different timings and other memory settings. No progress.
What may you recommend to check at first?

I gonna check these DIMMs on P5Q-E too, but only net week.

gtls on auto you lucky if you can do 505fsb

i can do 500fsb 4x1 d9gmh memory @ 1200 2.05v
the right gtl setting helps using less voltage
like i said u need to learn the board
if you want easy use your p5q