Quote Originally Posted by jdmR View Post
hey c-n how are the ocz reaper and sli
They all run very well. I have 3 x 2GB sets of GMH based 8500 SLI & all of them will do 1200mhz fully stable easy within OCZ voltage spec.

The 8000 Reapers are in my work station that runs 4GHz DDR1000 24/7. I haven't pushed them but I have had them running stable 1055mhz on the 266 strap @ 5.5.5.4.15.5.46 PL7 1.977v. These 8000's run a bit poor in my P35 board but the P45 loves them.

I haven't run my Reaper 6400's in a P45 board other than the T-Power so cant really say how good they go. Good as the 6400's are being Micron based which allow CL3~5 & uber voltage they still cant cut DDR1200 with low trfc like 4 x 1GB's so they are kind of obsolete for me performance wise.

Quote Originally Posted by Retro View Post
Weelkoo:

C-N:
I am having this same issue with my DFI LP JR P45 T2RS. Do you know if there is or will be an upcoming bios update for the LP JR to address this?
I really couldn't say but if it really is an issue then I'm sure DFI will sort it as they have done here. I would pop over to DFI Club & ask this question if I were you.

I have heard of this issue with the JR but thought it was/could be cured by adding a bit more vNB.