ASUS P5K Deluxe - Intel P35 Bearlake + E6600 B1 / Q6600 B3

[andressergio]

hey guys I'm having a hard time to make my bios 311 OCs stable with this 902...

I had 2x1GB Crucial Ballistix 1066 before and are dead...so I bought 2x2Gb mushkin ascent 1066 that require trfc values over 42 wich bios 311 can't provide...so i have to flash this 902 bios...i could make it till 3825 as you can see it some posts behind but i can't make it to 3906

this are my actual settings and prime small and blend fails...

Well I have to tell you that i passed all OC adjusting FSB = 1,3 and NB = 1,4 but i can't pass prime95 on my main best OC that is 3906 with mems at 1088 can you give me a hand ? It's failing both small and blend...

this are my bios settings

3906 (434x9) vcore set on bios 1,4750

JumperFree Configuration Settings
AI Overclocking: Manual
CPU Ratio Setting: 9
FSB Frequency: 434
PCI-E Frequency: 105
DRAM Frequency: DDR2-1088
DRAM Timing Control: Manual
CAS# Latency: 5
RAS# to CAS# Delay: 5
RAS# Pre Time: 5
RAS# ACT Time: 15
TWR: Auto
TRFC: 55 (tried 65 also and no go)
TWTR: Auto
TRRD:Auto
TRTP: Auto
DRAM Static Read Control: Disabled

Transaction Booster: Auto (should i try anything here ? )

CPU Voltage: 1.4750
CPU PLL Voltage: 1.50
FSB Termination Voltage: 1.30 (tried also 1.4 and no go)
Dram Voltage: 2.0 (tried also 2.1 and no go)
NB Voltage: 1.4
SB Voltage: 1.05
Clock Over-Charging Voltage: Auto
Load-Line Calibration: Enabled
CPU GTL Voltage Reference: 0.63
NB GTL Voltage Reference: 0.67
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: Auto
NB Clock Skew: Auto

With bios 311 and the ballistix never had to change NB and FSB values i don't know if are the mushkins or the new bios that is forcing me to adjust those...

Any help would be apreciated
Cheers all
Sergio