yep..
htt boot up clock the same as htt clock
vcore as needed
ram @ 800mhz divider
nb did 1 fid 04
cool and quiet disabled
which processor do you use? 9850? normally that should be easier then with 9750, but perhaps using lower multi and higher htt would work better? wasn't able to test high multiplier against high htt with the 9750 myself of course, but who might know?
I found 05/05 Bios is much better then ealier ones, but i have not tested the newest beta
full bios template (exactly my settings, besides all the ram subtimings (which are more or less left at AUTO values):
Code:>HT Link Control: HT Link Width......................... - AUTO HT Frequency.......................... - 1,6 GHz IH Flow Control Mode.................. - Disabled HT Link Tristate...................... - Disabled 2x LCLK Mode.......................... - Disabled Unit Id Clumping...................... - Disabled >CPU Feature: CPU DID.............................. - 1 CPU FID.............................. - 08 CPU-NB DID........................... - 1 CPU-NB FID........................... - 04 AMD CPU stepping..................... - P0 >DRAM Configuration: MCT Memory Timing.................... - Manual 2T Mode.............................. - Enabled Cas Latency Time..................... - 5 Pre Charge Delay (tRAS).............. - 14 DRAM RAS# Precharge.................. - 4 DRAN RAS# to CAS# Delay.............. - 5 Bank to Bank Cmd (TRRD).............. - Auto TRC.................................. - 11T TRTP................................. - Auto Write Recovery (TWR)................. - Auto Write-Read Command (TWTR)............ - Auto TRFC0................................ - 195ns TRFC1................................ - 195ns TRFC2................................ - 195ns TRFC3................................ - 195ns Trdrd................................ - Auto TrwtT0............................... - Auto Twrrd................................ - Auto Twrwr................................ - Auto CS/ODT Pin Fine Delay................ - Enabled Bank Swizzle Mode.................... - Enabled Auto Tweak Performance............... - Disabled Optimal Performance Mode............. - Disabled >ODC Control Mode: DRAM Drivers Weak Mode.............. - Normal Output Drivers Comp................. - Normal >Channel A: CPU On-die Termination.............. - 300 ohms +/- 20% DQS Drive Strength.................. - 1.00x Data Drive Strength................. - 1.00x MEMCLK Drive Strength............... - 1.00x Addr/Cmd Drive Strength............. - 1.50x CS/ODT Drive Strength............... - 1.50x CKE Drive Strenght.................. - 1.50x >Channel B: CPU On-die Termination.............. - 300 ohms +/- 20% DQS Drive Strength.................. - 1.00x Data Drive Strength................. - 1.00x MEMCLK Drive Strength............... - 1.00x Addr/Cmd Drive Strength............. - 1.50x CS/ODT Drive Strength............... - 1.50x CKE Drive Strenght.................. - 1.50x >PWM Settings: PWM Control.......................... - Enabled CPU VID Control...................... - 1.40000v CPU Vid Special Add.................. - Auto CPU NB Vlotage Control............... - 1.40000v CPU NB Vid Special Add............... - Auto DRAM Voltage Control................. - 2.12v SB PLL 1.2V Voltage.................. - 1.20v NB Core Voltage...................... - 1.250v NB PCI-E Voltage..................... - 1.170v NB HT Voltage........................ - 1.270v Genie BIOS Settings: Timing Mode.......................... - Manual Memory Clock value or Limit.......... - DDR 800 PCIE 3,4 State....................... - Auto PCIE 2 State......................... - x2 CPU TLB Cache Fix.................... - Disabled AMD K8 Cool & Quiet control.......... - Disabled CPU Clock Ratio...................... - Auto Spread Spectrum...................... - Disabled CPU Host/HTT Clock................... - 267mhz CPU Host/HTT Boot Up Clock........... - 267mhz CPU Host/HTT Adjustment Gap.......... - 5mhz PCIE Clock........................... - 100mhz
Reply With Quote
Bookmarks