Striker pwns EVGA with Q6600 G0

[ryanwhite123]

gettin! after 5 hours of messing about with settings i decided to flash to the latest bios version 1504, despite what people have said about the past few recent updates. And i managed to get 3.4ghz straight away using linflas settings! For some reason though it shows up as 3.83 under my computer? but in cpu z its only 3.4ghz. Which is still much better than i had before!


AI Tuning: Manual
Nvidia GPU Ex: Disabled
LinkBoost: Disabled

FSB - Memory Clock Mode: Unlinked
x FSB - Memory Raio: N/A
FSB (QDR), Mhz: 1700 (means 425FSB)
Actual FSB (QDR), Mhz: 1700
MEM (DDR), Mhz: 850 (means 425Mhz speeds)
Actual MEM (DDR), Mhz: 850

Vcore Voltage: 1.6
Memory Voltage: depending on ya ram
1.2v HT Voltage:1.6
NB Core Voltage:1.45
SB Core Voltage:1.6
CPU VTT Voltage:1.55
DDRII Controller Ref Voltage:AUTO
DDRII Channel A Ref Voltage:AUTO
DDRII Channel B Ref Voltage:AUTO

tCL (CAS Latency): 5
tRCD: 5
tRP: 5
tRAS: 15
Command Per Clock (CMD): 2 clock (2T)

Advance Memory Settings
tRRD: AUTO
tRC: AUTO
tWR: AUTO
tWTR: AUTO
tREF: AUTO
tRD: AUTO
tRFC: AUTO
Async Latency: AUTO

CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
MCP PCIE Spread Spectrum: Disabled
SATA Spread Spectrum: Disabled
LDT Spread Spectrum: Disabled

CPU Internal Thermal Control: Disabled
Limit CPUID MaxVal: Disabled
Enhanced C1 (C1E): Disabled
Execute Disable Bit: Disabled
Virtualization Technology: Disabled
Enhanced Intel Speedstep Tech: Disabled
LDT Frequency: 5x

PCIEX16_1 Frequency (Mhz): 100
PCIEX16_2 Frequency (Mhz): 100
PCIEX16_3 Frequency (Mhz): 100
SPP<->MCP Ref Clock, Mhz: 200


BTW, does anyone think that 1.6vcore could be too high? will it give off more heat etc ?


*update* i have just tried out the 3.6 linflas settings and i managed to get into windows fine, but it just froze up. Im going to get some sleep now though as its 4:30am. Im not sure if i can make a 3.6 stable on air and stock heat sink on the motherboard? What do people think?


Thanks, Ryan