Thanks largon, that would make more sense, because when I had the 2.1v the left trace went to the two end traces with a 16ohm reistor. (the ones written with ok) at this time the resistor with the blue circle was intact, but it didnt match the resistence of the other card, so I soldered a 33ohm resistor on top of it, however soon after this blue circled resistor broke... The remaining traces and resistors on the right are still ok... I'm just not sure what to do in place of the resistor with the blue circle... I'm thinking put a vr there and set it to 25ohms... It will probably be easier to just look at the pictures, all of the x marks show resistors that no longer exist, the black lines indicated traces that are ok... The second picture shows my new plan..



This is what I plan to do now...