Quote Originally Posted by Xilikon View Post
Looks great... I have been thinking about sleeving the PSU wires for some time. Mekrel, sleeving the ATX connector is that easy ? Any tips to share ?

The BitsPower connectors is also great
Very easy, especially the way I did it. I just wrote down what coloured wire went where and if it was a double wire (Some pins have two going into them).

Then I take out two pins at a time, starting with row 1-12 and sleeve those two then the next two and so fourth until 1-12 is done. Then I but a small rubber band around them to keep them together.

Then do the same for the bottom row (13-24) as I did for the top. That way I know better where the wires go back into. Then once they're individually sleeved, 10mm braid over the top.

Heat gun is a must, lighters never get a good shrink ratio for me.

To remove them, I used an old tool from when I bought an ACRyan Morf PSU braid kit. I've used pins before in the past, but they're a pain as when you pull the wire out (which takes some tugging) they fly out and you have to find them again